WITECH VCI POD Diagnostic Tool For Chrysler is designed to work on Chrysler, Jeep, Dodge, Ram vehicles.
WITECH VCI POD kit connects to a vehicle using the OBD II Cable. It must be connected to a laptop using a USB cable. It can also work with the DRB-III Emulator Software to perform most DRB-III diagnostic and reprogramming functions.
What should i pay attention when i install this Chrysler diagnostic software?
1. WITECH VCI POD contains DRB III emulator, please connect the vehicle to the WITECH before using DRB III emulator, and it needs one minute to open DRB III emulator.
2. When you want to use WITECH software to program, you’d better change the language to English; programming in English will be very stable.
3. WITECH software start is a bit slow; please wait until the screen has a full display before proceeding to the next step.
After connect the WITECH hardware with the computer, please check whether the driver is well installed, whether the software find the hardware. After open “wiTech Diagnostic Application” on the desktop, you can’t go on operating unless the “Device” status is green, as shown
FAQ:
Q1: Is it possible to use this tool to reprogram the ECM?
A1: Yes. You can use this Chrysler diagnostic tool to program ECM.
Q2: The wiTECH VCI POD works about one week, and prompt”the tool needs to be update to version 14.4”, stop to work any more, what’s wrong?
A2: That because you have updated it, please change another system or computer to install our software to check whether it can work, please make sure disconnect the network
Q3: If Chrysler Diagnostic Tool (WITECH VCI POD) have WLAN Mode?
A3: No, our WITECH VCI POD only have USB Mode